Goal
| # | Your goal in this lesson |
|---|---|
| 1 | Know the three big effect families (drive, time, modulation), what each does and roughly how to set it. |
| 2 | Know the usual pedal order and why it is the way it is. |
| 3 | Play the same progression clean (full chords, let-ring arpeggios, dynamics) and driven (power chords, palm muting, sustain for a lead). |
| 4 | Play the 24-measure etude four times in a row without a mistake at 84 BPM. |
Before you start
| # | Before you start, you should be able to |
|---|---|
| 1 | You know your amp’s basic knobs (gain, volume, EQ). |
| 2 | You can play power chords with palm muting and accents, and let-ring arpeggios. |
| 3 | You can bend and add vibrato in the minor pentatonic box. |
If any of these feel shaky, look up the matching concept in the Atlas.
Explanation
An honest note first: the player has three guitar sounds: clean electric, distorted electric and acoustic. There are no delay, reverb or chorus effects in it. So the etude doesn’t demonstrate the pedals themselves; it shows how your playing changes with the sound. Play sections A and D on clean; before section B, switch the player’s sound menu to distortion, and switch back to clean before section D. If you have pedals or an amp with effects, try the settings below on the etude.
The three families
1. Drive: overdrive, distortion, fuzz. They push the signal into saturation: the sound gets thicker, sustains longer and grows grit.
| Part | What happens |
|---|---|
| Overdrive | mild, like a tube amp turned up. Responds to how hard you pick: soft is almost clean, hard breaks up. Blues, classic rock, country solos. Start: gain about 9-10 o’clock, tone at noon, level a little above unity. Many players use it as a boost in front of an already crunchy amp. |
| Distortion | harder and more compressed, with less dynamic range. Hard rock, punk, metal. Start: gain about 1-2 o’clock; don’t scoop the mids too much, or the guitar disappears in a band. |
| Fuzz | the oldest and wildest, a buzzing square-wave sound. 60s rock, garage, stoner, some indie. |
2. Time effects: delay and reverb.
- Delay repeats what you play. Three knobs: time (how far apart the repeats are), feedback (how many), mix (how loud). A short slapback (about 80-120 ms, one repeat) is rockabilly and country. A delay in time with the song sounds musical: one beat = 60000 ÷ BPM milliseconds. At this lesson’s 84 BPM a quarter note is about 714 ms, an eighth 357 ms, and the popular dotted eighth 536 ms, which turns plain eighth-note arpeggios into a shimmering sixteenth-note pattern. Start: 2-3 repeats, mix 20-30 %.
- Reverb imitates a room: from a small room to a big hall. Spring reverb is the classic surf and blues sound; plate and hall are smoother. Start: mix low; too much reverb pushes the guitar to the back of the mix.
3. Modulation: chorus, phaser, flanger (and tremolo, vibrato). They make the sound move by slowly changing its pitch, phase or volume.
- Chorus: sounds like two guitars slightly out of sync: wide and shimmering. 80s pop and new wave, clean arpeggios, some grunge verses.
- Phaser: a rotating, “whooshing” sweep. Funk rhythm parts, 70s rock.
- Flanger: a stronger, jet-plane sweep. Use sparingly, for one part.
- Tremolo: the volume pulses. Surf, indie, ballads.
- Start: rate slow, depth medium. Fast and deep sounds seasick.
Pedal order
The usual chain from guitar to amp:
- Tuner (it gets the cleanest signal; most mute the output while tuning).
- Compressor (evens out the dynamics, popular in funk and country).
- Wah / filter.
- Drive: overdrive, distortion, fuzz. If you stack two, the milder one usually goes first.
- Modulation: chorus, phaser, flanger.
- Delay.
- Reverb (last, because it’s the “room” everything else is played into).
Why this way round? Drive amplifies and changes everything that reaches it. A delay in front of a distortion pedal would distort every repeat into a mush; after it, the repeats stay clear. Same with reverb. These are starting points, not laws: many players love a phaser before the drive, for example. If your amp has an effects loop, modulation and time effects go there, after the amp’s own distortion.
Which styles use what
| Style | Typical sound |
|---|---|
| Blues | light overdrive or a crunchy amp, a little spring reverb |
| Classic rock | crunch or overdrive, sometimes a delay on solos |
| Hard rock, metal | high-gain distortion, often a noise gate; delay on leads |
| Funk | clean, compressor, wah or phaser |
| Country | clean or light overdrive, compressor, slapback delay |
| 80s pop, new wave | clean with chorus and delay |
| Ambient, post-rock | clean, lots of delay and reverb |
| Grunge, indie | fuzz or distortion; chorus on clean verses |
Playing clean vs. playing driven (the etude)
| Part | What happens |
|---|---|
| Section A (1-8), clean | full, open chords and let-ring arpeggios over Em7 - Cadd9 - G - D. Your ring finger stays on B 3 through all four chords. On a clean sound every note and every change in strength is heard, so the dynamics come from your picking hand: mp, then mf. |
| Section B (9-16), drive | the same progression as power chords (E5, C5, G5, D5), all downstrokes, palm-muted with 3-3-2 accents. With distortion a full chord with thirds turns muddy, and every unmuted string adds noise; fewer strings and a tight palm are the rule. The dynamics come from the contrast between muted and open hits. |
| Section C (17-20), drive lead | a short melody in E minor pentatonic at the 12th fret with a full bend and vibrato. Distortion’s sustain is what lets long notes and bends sing. |
| Section D (21-24), clean | 12th-fret harmonics, arpeggios and a last soft Em7. This is where a delay or reverb would shine. |
Exercises
| Metronome | Repeats / time | Pass criterion |
|---|---|---|
1. Clean section (measures 1-8), clean sound Set the loop to 1-8 with the clean sound. | ||
| 60 → 84 BPM, in steps of 6. | 4 rounds at each tempo. | The arpeggio notes ring into each other evenly, the ring finger never leaves B 3, and you can hear the step from mp to mf. |
2. Drive section (measures 9-16), distortion Switch the player to distortion and set the loop to 9-16. | ||
| 60 → 84 BPM, in steps of 6. | 4 rounds at each tempo. | No string rings that shouldn’t; the accented hits are clearly open, the rest tight. |
3. The comparison Play measures 1-4 on distortion, then 9-12 on clean. Listen: the full arpeggio chords smear with distortion, and the power chords sound thin and small on clean. That’s why the playing style changes with the sound. | ||
| — | — | You can describe in one sentence what changes in each case. |
4. Drive lead (measures 17-20) Distortion, loop 17-20. | ||
| 60 → 84 BPM, in steps of 6. | 4 rounds at each tempo. | The bend lands on B (check it against G 16), and the long notes have an even vibrato. |
5. The whole etude Play measures 1-24 and switch the sound at measures 9 and 21 (or play the whole thing clean first, then distorted). | ||
| 60 → 84 BPM (stretch goal: 100). | 4 rounds in a row. | Four clean rounds at 84 BPM. |
6. Your own tone (optional, with your own gear) If you have pedals or a multi-effects unit: build a clean sound with chorus and a dotted-eighth delay (536 ms at 84 BPM) for section A, and a distortion with a short delay for section C. Write the settings down so you can find them again. | ||
Common mistakes
| Symptom | Cause | Fix |
|---|---|---|
| The distorted chords sound like mush | too many strings, or chords with thirds | use power chords and mute the other strings with the underside of your fingers. |
| Noise and hum in the drive section | open strings ring between the hits | ease the fretting hand off whenever you’re not playing; a noise gate helps but doesn’t replace muting. |
| The clean section sounds lifeless | every strum is equally hard | use dynamics: softer in 5-6, stronger in 7-8. |
| The delay makes everything blurry | the mix is too high or the repeats aren’t in time with the song | set the time from the BPM and keep the mix around 20-30 %. |
| The lead dies out on the clean sound | clean has less sustain | that’s normal; on clean, use shorter notes or let the reverb carry them. |
| Too much gain | the sound is thick alone but disappears in a band | turn the gain down until the chords stay clear; more volume, less gain. |
Checklist
| I can do it | Item |
|---|---|
| I can explain what drive, time and modulation effects do and name an example of each. | |
| I know the usual pedal order and why drive comes before delay and reverb. | |
| I can work out a delay time from the tempo. | |
| I can play section A clean with let ring and dynamics, and section B driven with tight palm muting. | |
| I can play the whole etude four times in a row at 84 BPM. |
The lessons you mark and the concepts you see are stored only in this browser; no account. Your path